![]() I prefer server core for the host operating system on my Hyper- V virtualization servers, but some things such as the i. SCSI Initiator settings are easier to configure through a GUI. Luckily Microsoft has included the i. ![]() ![]() Verbose status message is a built-in feature of Windows OS which comes enabled by default in Windows Server OS but its disabled in Windows client OS. This feature. This program will patch your theme engine files so you can use any 3rd party visual style on all Windows operating system since Windows XP. Installing ColdFusion on IIS 7 + Configure IIS for ColdFusion in Windows Vista and Windows Server 2008. SCSI Initiator control panel applet as part of R2. Log into your server and launch iscsicpl. The first time this command is run, you will receive the message shown below. Click “Yes” to start the i. ![]() ![]() ![]() SCSI service and set it to start automatically each time the server restarts: It will take a few seconds for the service to start and then the interface shown below will load. Click the “Discovery” tab at the top and then the “Discover Portal” button: Enter the IP Address or DNS Name of your SAN and click “OK”: Select the “Targets” tab, click the “Refresh” button, select the i. SCSI target, and click the “Connect” button: Only check the “Enable multi- path” check mark if the Multipath IO feature has been previously installed on the server. This option allows multiple i. Windows Server is the platform for building an infrastructure of connected applications, networks, and web services, from the workgroup to the data center. Universal Theme Patcher applies changes to Windows XP, Vista or 7 that allow you to use unofficial themes and change the way Windows looks. This is a portable. SCSI network paths from your server to your SAN to be active simultaneously. Click “OK”: The i. Convert your Windows Server 2008 to a Workstation! Windows Server 2008 to Workstation Manual.SCSI target should now show that it is connected: Select the “Favorite Targets” tab and verify the i. SCSI target shows up: Select the “Volumes and Devices” tab, click the “Auto Configure” button, and click “OK”: The i. SCSI initiator portion of the configuration is now complete. Enable “Allow MMC Remote Management” as shown in my “Remote Management of Hyper- V Server or Server Core” blog. From a machine that is running a full GUI version of an operating system (Vista or higher), launch the “Computer Management” MMC and remotely manage your core server. In “Disk Management”, locate the “Unknown” disk: Right click the Disk that shows up as “Unknown” and select “Online”: Right click the same Disk again and select “Initialize Disk”: Leave the defaults selected unless the disk is over 2. Tb (Terabytes) or expected to grow over 2. Tb in the future. I chose a “GPT” type disk since the i. SCSI target I am mounting is 2. Tb and may grow larger in the future: Right click the “Unallocated” space and select “New Simple Volume”. From this point forward, any server admin should be able to handle it since it’s just like an internal disk. Next week I’ll be writing a blog on Multipath IO for Windows Server 2. Server Core which will be available on Thursday (August 2. January 2. 7, 2. 01. The “Volumes and Devices” tab in the i. SCSI control panel applet should actually show drive letters (unless you’re mapping the volume as a folder) and must be configured after completing the drive setup inside the operating system. From what I’ve found, this helps the OS keep the correct drive letter mapped to the SAN volume during restarts, etc. April 1. 6, 2. 01. If you’re using an Equal. Logic SAN, I recommend installing the Equal. Logic Host Integration Tool (HIT) Kit before doing any of the i. SCSI configuration. See my “Multi. Path I/O on Server Core with the Equal. Logic HIT Kit” blog for more information.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
September 2017
Categories |